Compensating resistance needed
 Public Forums   2017-04-12 12:06:42 +02:00   Comments: 2    Viewed: 7709

  1. I just fitted a 123/Mercedes-6-R-V to my 220SE with M127IV Motor. Works fine so far. The original ignition coil (Bosch TK12A9) and compensation resistor (Bosch ZWJ11Z4Z, 0,9 Ohm) are still in place. Is that correct or are there any improvements (e.g. by removing the resistor or changing the coil)? Regards Ralf
    , 2017-03-27 10:01:05 +02:00
  2. Leen APK
    Leen APK Administrator Staff Member
    Dear Ralf, we advise to remove the resistor and use the Beru ZS109 coil. Best regards, Leen APK
    Leen APK, 2017-04-12 12:06:42 +02:00
  3. (You must log in or sign up to post here)

Report Post

Write your reason

Log in | Sign up
Tems & Conditions!
Help!